BMP180 Barometric Pressure Sensor Module

SKU: SE65345
60.00 (Incl. Tax)
Description:- BMP180 Sensor is an extremely precise low cost sensor from Bosch for measuring barometric pressure and temperature. Because pressure changes

Rain Drop Sensor Module Rain Sensor for Arduino

SKU: SE89857
80.00 (Incl. Tax)
Product type: rain sensor module Function: rain detection and rainfall intensity measurement and monitoring Weight: aprx 8g PCB or module

CD 4052 IC

SKU: SE24326
25.00 (Incl. Tax)
CD 4052 IC No Guarantee No Warranty

SL100 Transistor

SKU: SE39581
20.00 (Incl. Tax)
SL100 is a general purpose, medium power NPN transistor. It is mostly used as switch in common emitter configuration. The

Momentary Push Button Switch OFF-ON Horn Green Plastic 3A 125V

SKU: SE42276
45.00 (Incl. Tax)
Material: PlasticColor: GreenVoltage: 3A 125VLeads: Solder lugsContacts configuration: POFSwitch method: Push to on/off No Guarantee No Warranty Product image is

CD4051 4051 IC 16 pin – 8 Channel analog Multiplexer/Demultiplexer

SKU: SE43175
25.00 (Incl. Tax)
CD4051 4051 IC 16 pin – 8 Channel analog Multiplexer/Demultiplexer No Guarantee No Warranty

Shaft Dia-6mm with Length – 5 inch Material-MS

SKU: SE47285
30.00 (Incl. Tax)
Description This is 6mm Shaft/Rod with the length of- 5inch, it has 2 holes at both ends. Technical Specification: Material

36mm PVC Heat Shrink Sleeve For Battery Pack 1M

SKU: SE36698
15.00 (Incl. Tax)
One of the best ways to seal your battery is by using heat shrink. It can protect your battery from
ELECTRONICS

KK 2.1.5 Flight Controller Board

SKU: SE33942
4,500.00 (Incl. Tax)
The KK2.1 is next big evolution of the first generation KK flight control boards. The KK2.1 was engineered from the

1400KV BLDC Brushless Motor

SKU: SE75998
410.00 (Incl. Tax)
A2212 is a brushless outrunner dc motor specifically made to power Quadcopters and Multirotors. It is a 1400kV motor. It

Infra Red IR Smart car Obstacle Avoidance Sensor

SKU: SE85351
40.00 (Incl. Tax)
IR Sensor module has great adaptive capability of the ambient light, having a pair of infrared transmitter and the receiver

3D Printer RAMPS 1.4 Control Board

SKU: SE45517
280.00 (Incl. Tax)
Fully assembled & tested, no soldering required It is designed to fit the entire electronics needed for a RepRap in

12 Volt 1.5 Amp. Battery

SKU: SE97521
236.00 (Incl. Tax)
12 Volt 1.5 Amp. Battery No Guarantee No Warranty

12 Volt 2 Amp. Battery

SKU: SE39157
300.00 (Incl. Tax)
12 Volt 2 Amp. Battery No Guarantee No Warranty